20.4.1 StatusEnumeration

This data type is an enumeration of the possible operation modes of the ice machine. The enumeration values are defined in Table 71.

Table 71 — StatusEnumeration values
Value Description
INIT_0Commissioning, started manually (switch on) or automatically (after cleaning)
WATER_PURGE_1Existing water in the tray is flushed out and fresh water is filled for the next cycle
PRE_CHILL_2Precooling of the evaporator for xx seconds during the initial commissioning
FREEZE_3The water freezes on the evaporator to form ice
HARVEST_4Ice is harvested
BIN_FULL_5The state indicates that the ice container is full and that ice making has been stopped
CLEAN_6Ice machine is running through the cleaning steps
OFF_7Ice machine is switched off
SLEEP_MODE_8Power failure detected, system clock continues to run
STANDBY_9State after a temperature sensor error
SAFE_MODE_10Continue with ice making following an error
WATER_OUTAGE_11State with a lack of water
HPCO_DELAY_ACTIVE_12Maintenance state when the overpressure switch is activated and no ice is made for xx minutes
CURTAIN_OPEN_13Curtain was opened because there is an ice slab between the evaporator and the container.
PRODUCTION_TEST_14Ice machine is in the function test mode (at the manufacturer)
SAFE_MODE_PRECHILL_15Like the PRE_CHILL_2 state, but after a SAFE_MODE_10 state
SAFE_MODE_FREEZE_16Like the FREEZE_3 state, but after a SAFE_MODE_10 state
SAFE_MODE_HARVEST_17Like the HARVEST_4 state, but after a SAFE_MODE_10 state
SAFE_MODE_FULL_BIN_18Like the BIN_FULL_5 state, but after a SAFE_MODE_10 state