Id – OPC UA for Plastics and Rubber Machinery – General Type Definitions

OPC UA for Plastics and Rubber Machinery – General Type Definitions

v1.03

1Scope
2Normative references
3Terms, definitions and conventions
- 3.1Overview
- 3.2Conventions used in this document
4General information to OPC UA interfaces for plastics and rubber machinery and OPC UA
- 4.1Introduction to OPC UA interfaces for plastics and rubber machinery
- 4.2Introduction to OPC Unified Architecture
5Use cases
6General requirements
7Container concept
8MachineInformationType
9LogbookEvent
10MachineConfigurationType
11MachineMESConfigurationType
12MachineStatusType
13Users
- 13.1UsersType
- 13.2UserType
14MachineMESStatusType
15Moulds
- 15.1MouldsType
- 15.2MouldType
16PowerUnits
- 16.1PowerUnitsType
- 16.2PowerUnitType
17TemperatureZones
- 17.1TemperatureZonesType
- 17.2TemperatureZoneType
18JobsType
19CycleParametersEventType
20ProductionDatasetManagementType
21IdentificationType
- 21.1Properties included in ComponentType
- 21.2Additional property YearOfConstruction
22MonitoredParameterType
23ControlledParameterType
24ClosedLoopControlType
25MaintenanceType
26DataTypes for minimal error handling for devices without alarm support
- 26.1ActiveErrorDataType
- 26.2ClassifiedActiveErrorDataType
27Subtypes of HelpOffNormalAlarmType
- 27.1HelpOffNormalAlarmType
- 27.2MonitoredParameterAlarmType
28Configuration Parameters
29MaterialListType
30MaterialType
31EnergyType
32MeasuringDevices
- 32.1MeasuringDevicesType
- 32.2MeasuringDeviceType
33StartDeviceType
34DriveType
35DiagnosticsType
36Profiles and Conformance Units
37Namespaces
- 37.1Namespace Metadata
- 37.2Handling of OPC UA Namespaces
38(normative)OPC 40083 Namespace and mappings

16.2.4 Id

The Id Property represents the Id of the PowerUnit.