8.2 InterfaceTypes for Export and use within other OPC UA models

This section specifies InterfaceTypes which are intended to be used by other companion specifications or for vendor specific models. These "Export"- Interfaces are the same then defined in the OPC UA for Machinery part 40001-5 IMachineryDriveAxisType and IMachineryServoDriveAxisType definitions and contain an extract of variables to be used as an easy PTS or drives model showing the basic states and information about a drive or servo drive axis. All variables in these interfaces are taken out of the complete PTS model specified in this companion specification.

8.2.1 IDriveAxis Interface

The IDriveAxis InterfaceType contains the basis states and information for a PTS variable speed or variable frequency drive axis type.

Table 58 - IDriveAxis Interface
AttributeValue
BrowseNameIDriveAxis
IsAbstractTrue
ReferencesNode ClassBrowseName DataTypeTypeDefinitionOther
Subtype of the 0:BaseInterfaceType defined in OPC 10000-5.
0:HasComponentVariableAxisType0:UInt160:MultiStateValueDiscreteTypeO, RO
0:HasComponentVariableControlMode0:UInt160:MultiStateValueDiscreteTypeO, RO
0:HasComponentVariableAxisState0:UInt160:MultiStateValueDiscreteTypeO, RO
0:HasComponentVariableBrakeState0:UInt160:MultiStateValueDiscreteTypeO, RO
0:HasComponentVariableVelocityActualValue0:Float0:BaseAnalogTypeO, RO
0:HasComponentVariableVelocityFollowingError0:Float0:BaseAnalogTypeO, RO
0:HasComponentVariableTorqueForceActualValue0:Float0:BaseAnalogTypeO, RO
0:HasComponentVariableShaftTurningDirection0:UInt160:MultiStateValueDiscreteTypeO, RO
0:HasComponentVariableAccelerationActualValue0:Float0:BaseAnalogTypeO, RO
0:HasComponentVariableMotorTemperature0:Float0:BaseAnalogTypeO, RO
0:HasComponentVariableConverterTemperature0:Float0:BaseAnalogTypeO, RO
Conformance Units

The AxisType Variable contains the mechanical drive type of the represented Powertrain Axis Object modelled as 0:MultiStateValueDiscreteType (Corresponds to the AxisType Variable of the PtDriveAxisType) . The content of the EnumValues lookup table Property is defined in Table 20.

For a description of the other Variables see Table 54.

8.2.2 IServoDriveAxis Interface

The IServoDriveAxis InterfaceType contains the basis states and information for a PTS positioning or servo drive axis type. This InterfaceType shall not be used if the axis is only operating as a spindle or variable speed drive without any positioning functionality. In case of a spindle with positioning functionality, which is currently operating in variable speed mode, the access to Variables of the interface related to the positioning mode, shall return the BAD StatusCode in this case.

Table 59 - IServoDriveAxis Interface
AttributeValue
BrowseNameIServoDriveAxis
IsAbstractTrue
ReferencesNode ClassBrowseName DataTypeTypeDefinitionOther
Subtype of the IDriveAxis InterfaceType.
0:HasComponentVariableHomingState0:UInt160:MultiStateValueDiscreteTypeO, RO
0:HasComponentVariablePositionActualValue0:Double0:BaseAnalogTypeO, RO
0:HasComponentVariablePositionFollowingError0:Float0:BaseAnalogTypeO, RO
0:HasComponentVariablePositionOffset0:Float0:BaseAnalogTypeO, RO
Conformance Units

The PositionOffset Variable contains the home position shift for adjustment of axis mechanical zero (see HomingPointOffset Variable in the Homing Folder also).

For a description of the other Variables see Table 54.