A Part in this Companion Specification is represented by a value of the 3:ISA95MaterialDataType which contains an entry in the Properties field. Table 15 lists all Parameters a needed by a Part element.
Table 15 – 3:ISA95MaterialDataType Parameters of a Part
|
ParameterName |
DataType |
Description |
|
VECPartVersion |
Contains the master data of the part. Only the ID of the 7:PartVersion is mandatory. The Values of Company, PartNumber, 7:PartVersion are optional. |
|
|
VECDocumentVersion |
7:DocumentVersion |
Contains the master data of the article. The field Specification contains important specifications for that part. The kind of specification depends on the process of the machine. |
The MaterialDefinitionID represents the part number, which must be unique within the company.
The MaterialClassID is restricted to the value range of the VEC 7:PrimaryPartType. The table contains the MaterialClassID (7:PrimaryPartType) for the different processes.
Table 16 – MaterialClassIDs used in this Companion Specification for Parts
|
Process |
MaterialClassID |
|
Cut |
Wire |
|
Strip |
Wire |
|
Seal |
CavitySeal, MultiCavitySeal |
|
Crimp |
Terminal, WireEndAccessory, PluggableTerminal, RingTerminal, WireEndAccessory, (SpliceTerminal, BoltTerminal, BridgeTerminal, OpenWireEndTerminal) |
The linkage between the 3:ISA95MaterialDataType and the VEC is established through the 7:PartVersion. The PartVersion.PartNumber must be the same as in MaterialDefinitionID.
The field Specification of the 7:DocumentVersions contains important specifications for the Part. The kind of specification depends on the processes of the machine. If a machine covers more than one process, all Specifications need to be implemented. Section 10.2 contains more information about the specification and the content which is needed.
Table 17 – Needed VEC Specifications for a Part
|
ProcessName |
Specifications |
|
Crimp |
WireSpecification/ |
|
Cut |
WireSpecification |
|
Seal |
WireSpecification/ |
|
Slit |
WireSpecification |
|
Strip |
WireSpecification |
It is recommended that only one entry is used for each Part. If the quantity of the Part is more than one, the Quantity field should be used.