Errata exists for this version of the document.
The Total Aggregate defined in Table 19 performs the following calculation for each interval:
Total = TimeAverage x ProcessingInterval (seconds)
where: TimeAverage is the result from the TimeAverage Aggregate, using the ProcessingInterval supplied to the Total call.
The resulting units would be normalized to seconds, i.e. [TimeAverage Units] x seconds.
The Aggregate StatusCode will be determined using the StatusCode Calculation (see 5.3).
Table 19 – Total Aggregate summary
|
Total Aggregate Characteristics |
||
|
Type |
Calculated |
|
|
Data Type |
Double |
|
|
Use Bounds |
Interpolated |
|
|
Timestamp |
StartTime |
|
|
|
||
|
Status Code Calculations |
||
|
Calculation Method |
Custom Good if no Bad values are skipped and Good values are used, Uncertain if Bad values are skipped or if Uncertain values are used |
|
|
Partial |
Set Sometimes If an interval is not a complete interval |
|
|
Calculated |
Set Always |
|
|
Interpolated |
Not Set |
|
|
Raw |
Not Set |
|
|
Multi Value |
Not Set |
|
|
|
||
|
Status Code Common Special Cases |
||
|
Before Start of Data |
Bad_NoData |
|
|
After End of Data |
Value extrapolated, Uncertain status |
|
|
No Start Bound |
Calculate Partial Interval |
|
|
No End Bound |
Extrapolate data, Uncertain status |
|
|
Bound Bad |
NA |
|
|
Bound Uncertain |
NA |
|