5 Model ToC Previous Next

5.8 Alarm model ToC Previous Next

5.8.9 PlaceInService Method ToC Previous Next

The PlaceInService Method is used to set the OutOfServiceState to False of a specific Alarm instance. It is only available on an instance of an AlarmConditionType that also exposes the OutOfServiceState. Normally, the NodeId of the ObjectInstance is passed as the ObjectId to the Call Service. However, some Servers do not expose Condition instances in the AddressSpace. Therefore, Servers shall allow Clients to call the PlaceInService Method by specifying ConditionId as the ObjectId. The Method cannot be called with an ObjectId of the AlarmConditionType Node.

Signature

PlaceInService ();

Method result codes in Table 47 (defined in Call Service)

Table 49 – PlaceInService result codes

Result Code Description
Bad_MethodInvalid The MethodId provided does not correspond to the ObjectId provided. See OPC 10000-4 for the general description of this result code.
Bad_NodeIdInvalid Used to indicate that the specified ObjectId is not valid or that the Method was called on the ConditionType Node.
See OPC 10000-4 for the general description of this result code.

Comments

The PlaceInService Method applies to an Alarm instance, even if it is not currently in the Active State.

Table 48 specifies the AddressSpace representation for the PlaceInService Method.

Table 50 – PlaceInService Method AddressSpace definition

Attribute Value
BrowseName PlaceInService
References NodeClass BrowseName DataType TypeDefinition ModellingRule
           
AlwaysGeneratesEvent ObjectType AuditConditionOutOfServiceEventType Defined in 5.10.12    

Previous Next