9 Mapping of DataTypes ToC Previous Next

9.2 Enumeration DataTypes ToC Previous Next

9.2.1 AutoIdOperationStatusEnumeration ToC Previous Next

This DataType is an enumeration that specifies the status for the AutoID operations like scan, read, write, lock or kill. Its values are defined in Table 33.

Not all status values are usable for all AutoID reader types. The table contains flags to indicate the expected status values for the different reader types.

Table 33 – AutoIdOperationStatusEnumeration Values

Name Description OCR Opt. RFID RTLS
SUCCESS_0 Successful operation X X X X
MISC_ERROR_TOTAL_1 The operation has not been executed in total     X  
MISC_ERROR_PARTIAL_2 The operation has been executed only partial     X  
PERMISSON_ERROR_3 Password required     X  
PASSWORD_ERROR_4 Password is wrong     X  
REGION_NOT_FOUND_ERROR_5 Memory region not available for the actual tag     X  
OP_NOT_POSSIBLE_ERROR_6 Operation not supported by the actual tag     X  
OUT_OF_RANGE_ERROR_7 Addressed memory not available for the actual tag     X  
NO_IDENTIFIER_8 The operation cannot be executed because no tag or code was inside the range of the AutoID Device or the tag or code has been moved out of the range during execution X X X X
MULTIPLE_IDENTIFIERS_9 Multiple tags or codes have been selected, but the command can only be used with a single tag or code X X X  
READ_ERROR_10 The tag or code exists and has a valid format, but there was a problem reading the data (e.g. still CRC error after maximum number of retries)   X X  
DECODING_ERROR_11 The (optical) code or plain text has too many failures and cannot be detected X X    
MATCH_ERROR_12 The code doesn’t match the given target value X X    
CODE_NOT_SUPPORTED_13 The code format is not supported by the AutoID Device   X    
WRITE_ERROR_14 The tag exists, but there was a problem writing the data     X  
NOT_SUPPORTED_BY_DEVICE_15 The command or a parameter combination is not supported by the AutoID Device X X X X
NOT_SUPPORTED_BY_TAG_16 The command or a parameter combination is not supported by the tag     X  
DEVICE_NOT_READY_17 The AutoID Device is in a state not ready to execute the command X X X X
INVALID_CONFIGURATION_18 The AutoID Device configuration is not valid X X X  
RF_COMMUNICATION_ERROR_19 This error indicates that there is a general error in the communication between the transponder and the reader     X X
DEVICE_FAULT_20 The AutoID Device has a hardware fault X X X X
TAG_HAS_LOW_BATTERY_21 The battery of the (active) tag is low     X X

Its representation in the AddressSpace is defined in Table 34.

Table 34 – AutoIdOperationStatusEnumeration Definition

Attribute Value
BrowseName AutoIdOperationStatusEnumeration
IsAbstract False

Subtype of Enumeration defined in OPC 10000-5.

References NodeClass BrowseName DataType TypeDefinition Other
0:HasProperty Variable 0:EnumValues 0:EnumValueType [] 0:PropertyType  

Previous Next