PlasticsRubber - Extrusion - Calibrator

OPC 40084-10: PlasticsRubber - Extrusion - Calibrator

Released 1.00 (Replaced by 2.00)

2020-04-22

This document is subject to the license terms described here.

The general OPC Foundation specification license agreement also applies and can be found here.

This document is a copy of the original which can be found here.

This document defines nodes in the following nodesets:

http://opcfoundation.org/UA/PlasticsRubber/Extrusion/Calibrator/

1 Scope 2 Normative references 3 Terms, definitions and conventions 3.1 Overview 3.2 Conventions used in this document 3.3 Abbreviations 4 General information to OPC UA interfaces for plastics and rubber machinery and OPC UA 5 Use cases 6 Basic security requirements 6.1 Application Security 6.2 User security/Access control 6.2.1 On calibrator 6.2.2 On MES 7 Calibrator_InterfaceType 7.1 Calibrator_InterfaceType Definition 7.2 DeviceClass 7.3 PositionZ, PositionsX, PositionsY 7.4 PositionsPipeSupport 7.5 CalibrationZonesType 7.5.1 WaterFlowIn, WaterFlowOut 7.5.2 WaterTemperatureIn, WaterTemperatureOut 7.5.3 CalibrationZoneType 7.5.3.1 Name 7.5.3.2 Position 7.5.3.3 IsPresent 7.5.3.4 VacuumPumps 7.5.3.5 WaterPumps 7.5.3.6 WaterTemperature 7.5.3.7 WaterFlow 7.5.3.8 Water level 7.5.3.9 AirShowerPressure 7.5.3.10 AdditionalMeasuringDevices 8 Profiles and Conformance Units 9 Namespaces 9.1 Namespace Metadata 9.2 Handling of OPC UA Namespaces Annex A (normative)OPC 40084-10 Namespace and mappings