The OPC UA Method Result codes, from OPC 10000-4, are copied in Table 56.
Table 56 – OPC UA Method Result Codes
|
Result Code |
Description |
|
Bad_MethodInvalid |
See OPC 10000-4 for the description of this result code. (The method id does not refer to a method for the specified object.) |
|
Bad_NotImplemented |
See OPC 10000-4 for the description of this result code. (Requested operation is not implemented.) |
|
Bad_NodeIdUnknown |
See OPC 10000-4 for the description of this result code. (Used to indicate that the specified object is not valid) |
|
Bad_ArgumentsMissing |
See OPC 10000-4 for the description of this result code (The client did not specify all of the input arguments for the method.) |
|
Bad_TooManyArguments |
See OPC 10000-4 for the description of this result code (The client specified more input arguments than defined for the method.) |
|
Bad_InvalidArgument |
See OPC 10000-4 for the description of this result code. (Used to indicate in the operation level results that one or more of the input arguments are invalid. The inputArgumentResults contain the specific status code for each invalid argument.) |
|
Bad_TypeMismatch |
See OPC 10000-4 for the description of this result code. (Used to indicate that an input argument does not have the correct data type.) |
|
Bad_OutOfRange |
See OPC 10000-4 for the description of this result code. (Used to indicate that an input argument is outside the acceptable range.) |
|
Bad_Timeout |
See OPC 10000-4 for the description of this result code. (The operation timed out. – the server did not respond to the command) |
|
Bad_InvalidState |
See OPC 10000-4 for the description of this result code. (The operation cannot be completed because the object is closed, uninitialized or in some other invalid state.) |
The job order methods’ return status codes are defined as a bit map in a UInt64 variable, allowing for multiple codes to be defined at the same time. The codes and bitmap positions are defined in Table 57. In the OPC format, the bit positions start at bit 0 for the least significant digit.
Table 57 – ISA-95 Methods Return Status Codes
|
Bit Position |
Description |
Notes |
|
0 |
No Error |
If bit 0 set (UInt64 value = 1) then there are no errors. This is returned on all successful method calls. |
|
1 |
Unknown Job Order ID |
The Job Order ID is unknown by the Information Receiver/Provider |
|
2 |
Invalid Job Order Command |
The command cannot be executed by the Information Receiver. |
|
3 |
Invalid Job Order Status |
The Job Order status is unknown. |
|
4 |
Unable to accept Job Order |
The Job Order cannot be accepted |
|
32 |
Invalid request |
The request is invalid due to an unspecified reason. |
|
33-63 |
Reserved |
These values are reserved for use in specific implementations and should be defined in the implementation specification. |