Errata exists for this version of the document.

In OPC UA Aggregates the StatusCode is used to indicate the conditions under which a value or Event was stored, and thereby can be used as an indicator of its usability. Due to the nature of aggregated data, additional information beyond the basic quality and call result code needs to be conveyed to the client. For example, whether or not the result was Interpolated, were all data inputs to a calculation of Good quality, etc.

In the following, Table 8 contains codes with Bad severity indicating a failure; Table 9 contains codes with Uncertain severity indicating that the value has been retrieved under sub-normal conditions. It is important to note, that these are the codes that are specific for OPC UA Aggregates and that they supplement the codes that apply to all types of data; they are therefore defined in OPC 10000-4, OPC 10000-8 and OPC 10000-11.

Table 8 – Bad operation level result codes

Symbolic Id	Description
Bad_AggregateListMismatch	The requested number of Aggregates does not match the requested number of NodeIds. When multiple Aggregates are requested, a corresponding NodeId is required for each AggregateFunction.
Bad_AggregateNotSupported	The requested AggregateFunction is not supported by the Server for the specified Node.
Bad_AggregateInvalidInputs	The Aggregate value could not be derived due to invalid data inputs, errors attempting to perform data conversions or similar situations.

Table 9 – Uncertain operation level result codes

Symbolic Id	Description
Uncertain_DataSubNormal	The value is derived from raw values and has less than the required number of Good values.