The RemoveFromService Method is used to suppress a specific Alarm instance. It is only available on an instance of an AlarmConditionType that also exposes the OutOfServiceState. Normally, the NodeId of the object instance is passed as the ObjectId to the Call Service. However, some Servers do not expose Condition instances in the AddressSpace. Therefore, Servers shall allow Clients to call the RemoveFromService Method by specifying ConditionId as the ObjectId. The Method cannot be called with an ObjectId of the AlarmConditionType Node.

Signature

RemoveFromService();

Method result codes in Table 61 (defined in Call Service).

Table 61 – RemoveFromService result codes

Result Code

Description

Bad_MethodInvalid

The MethodId provided does not correspond to the ObjectId provided. See 10000-4 for the general description of this result code.

Bad_NodeIdInvalid

Used to indicate that the specified ObjectId is not valid or that the Method was called on the AlarmConditionType Node.

See 10000-4 for the general description of this result code.

Comments

Instances that do not expose the OutOfService State shall reject RemoveFromService calls. RemoveFromService Method applies to an Alarm instance, even if it is not currently in the Active State.

Table 62 specifies the AddressSpace representation for the RemoveFromService Method.

Table 62 – RemoveFromService Method AddressSpace definition

Attribute

Value

BrowseName

RemoveFromService

References

NodeClass

BrowseName

DataType

TypeDefinition

ModellingRule

AlwaysGeneratesEvent

ObjectType

AuditConditionOutOfServiceEventType

Defined in 5.10.12

ConformanceUnits

A & C OutOfService

If Auditing is supported, this Method shall generate an Event of AuditConditionOutOfServiceEventType for all invocations of the Method.